2014 RAM C/v-Tradesman Air Filter in Denver, CO

The engine air filter is inside the under‑hood airbox on the driver side of the engine bay, just upstream of the intake duct.

This location lets the 3.6L V6 draw clean air before it reaches the throttle body. At Larry H. Miller Chrysler Dodge Ram FIAT Denver, technicians open the housing, inspect the seal and clips, and ensure the intake snorkel is secure—important on work vans that see dusty routes around Denver and Aurora. We also check for debris that can restrict airflow.

• Driver-side airbox ahead of the engine
• Upstream of the mass airflow path/throttle body
• Quick access for inspection and replacement

The cabin air filter sits behind the glove box in the HVAC intake area.

On the 2014 Ram C/V Tradesman, the filter slides into a slot behind the glove compartment, which must be lowered to access the cover panel. Our Denver service team replaces it without damaging trim, then verifies blower performance and checks for leaves or dust that can accumulate during Colorado’s pollen and wildfire seasons.

• Accessed by lowering the glove box
• Installed in the HVAC intake slot
• Panel cover must be properly re-seated to prevent bypass

The engine air filter protects the 3.6L V6’s intake air, while the cabin air filter cleans air entering the passenger compartment via the HVAC.

The engine filter keeps dust out of the combustion path to maintain power and efficiency, especially important with Denver’s variable road conditions. The cabin filter targets pollen, dust, and odors so the driver area remains comfortable. Both filters are serviceable and benefit from inspections after heavy use.

• Engine filter = airbox in engine bay
• Cabin filter = behind glove box/HVAC intake
• Different media types and purposes

Common signs include reduced power, lower fuel economy, rough idle (engine), and weak HVAC airflow or musty odors (cabin).

On work routes around Denver, dust can load the engine filter and restrict intake flow, making the 283-hp V6 feel sluggish. Inside the van, a dirty cabin filter limits defrost and cooling performance. Our technicians can confirm the cause and replace filters using OEM-spec parts for reliable sealing and filtration.

• Engine: hesitation on acceleration
• Engine: darker, debris-laden filter element
• Cabin: reduced fan output and lingering smells

Yes—engine filter replacement is typically DIY-friendly; cabin filters often require glove box removal and careful panel handling.

Many owners can swap the engine filter at home, but a dealer visit adds value: intake/seal checks, MAF-area inspection, and confirmation of Mopar-spec fit. In Denver, our team also checks for dust ingress common on construction routes, ensuring the housing seals properly so unfiltered air can’t bypass the element.

• DIY: engine filter in airbox with basic tools
• Cabin: trim access; risk of mis-seated cover
• Dealer adds OEM fit, inspections, and disposal

Yes—our Denver service department installs Mopar Genuine engine and cabin air filters.

Using Mopar filters ensures proper fitment for the 3.6L V6 intake system and the HVAC housing on the 2014 Ram C/V Tradesman. This helps maintain factory airflow, sealing, and filtration efficiency. We provide up-front pricing, proper disposal, and a documented inspection so you know the job was done to OEM standards.

• Mopar Genuine Parts for RAM vehicles
• Correct dimensions and filter media
• Documented inspection with each service

Book online at https://www.lhmchryslerdodgeramfiatdenver.com/service/schedule-service-denver.htm.

Use our secure scheduler to choose a time that fits your day, or call (720) 734-3858 for assistance. Larry H. Miller Chrysler Dodge Ram FIAT Denver is located at 2727 South Havana Street and serves drivers from Denver, Aurora, Parker, Centennial, and Littleton. Check current service specials before you book.

• Online scheduling in minutes
• Phone support: (720) 734-3858
• Convenient Havana Street location

It uses a 3.6L V6 (283 hp, 260 lb-ft), which requires an OEM-spec intake filter sized for the Pentastar airbox.

The correct filter maintains airflow and sealing for the 6-speed automatic’s drivability and fuel economy. Using Mopar-spec media helps the engine breathe properly at Denver’s elevation, especially under load or towing up to 3,600 lbs. Our team verifies the housing seal so no unmetered air bypasses the element.

• 3.6L V6 Pentastar intake layout
• OEM-spec filter dimensions and seal profile
• Supports rated performance and MPG

No—the 2014 Ram C/V Tradesman’s flex-fuel (unleaded/E85) system does not change the required engine or cabin air filter.

Air filter selection is based on the intake and HVAC housings, not the fuel you use. Whether you run gasoline or E85, we install Mopar-spec filters that match the airbox and cabin slot. In Denver, we also inspect for dust and debris that can load filters faster on mixed city/highway routes.

• Same filter regardless of unleaded or E85
• Fitment is housing-specific, not fuel-specific
• Local driving conditions influence service frequency

Our service process is straightforward and thorough to keep your 2014 Ram C/V Tradesman breathing freely. First, we inspect the engine airbox, seals, and intake duct for cracks or loose clamps, then remove and evaluate the element for dirt loading or oil contamination. If replacement is needed, we install a Mopar-spec filter and confirm the airbox closes evenly with no gaps. For the cabin, we lower the glove box, remove the HVAC access cover, check for leaves or debris, and install a fresh cabin filter with the correct airflow orientation. Before closing, we verify blower output and ensure the cover is fully seated to prevent bypass. Book your visit online—use our secure scheduler and get your questions answered by phone at (720) 734-3858. To reserve a time now, schedule service.

We proudly serve drivers across Denver, Aurora, Parker, Centennial, and Littleton with air filter services tailored to Front Range conditions. Dry spells, construction dust, spring pollen, and wildfire particulates can load filters faster, reducing engine performance and HVAC airflow. Our factory-certified team inspects both engine and cabin filters, checks housings for proper sealing, and installs Mopar Genuine replacements to maintain designed airflow and filtration. You can relax in our modern lounge while we work, or quickly drop in during weekday service hours (Mon–Fri 7:00 AM–6:00 PM, Sat 8:00 AM–5:00 PM). Ready to visit Larry H. Miller Chrysler Dodge Ram FIAT Denver at 2727 South Havana Street? Call (720) 734-3858, explore current service specials, or schedule an appointment.

The 2014 Ram C/V Tradesman uses a 3.6L V6 with an under‑hood airbox designed for a Mopar-spec panel filter that seals tightly against the housing lip. The cabin filter installs behind the glove box and is directional—install with the arrow following HVAC airflow. Using OEM-spec media helps the 283-hp, 260 lb-ft powertrain maintain throttle response and supports HVAC performance in dusty or high‑pollen periods around Denver. During service, we inspect the intake duct, box clips, and the cabin access panel to eliminate unfiltered air bypass. Bring your 2014 Ram C/V Tradesman to Larry H. Miller Chrysler Dodge Ram FIAT Denver in Denver for OEM-spec filter service — schedule service.